Tolerance wall thickness of steel plate

Could you please guide to check material of steel plate EN 10025 S275JR?
Dimension tolerance and wall thickness allowance.
Which specifications to refer to evaluate of acceptable/rejection?

1 Like

Easy to check material: visual inspection and dimensional inspection of width, length and thickness.
Review MTC shall follow PO and grade to verify test results such

  • Inspection documents
  • Material specification and grades,
  • Mechanical properties,
  • Chemical compositions,
  • Steel making process, see section 6.
  • FF - fully skilled steel, delivery conditions +N, or +AR, or +TCMP....
    
  • Additional requirement (if any),

Tolerance of wall thickness: see section 7.7 in this spec and EN 10029 class A.

1 Like

Lear more in EN 10025-1 2004.

2.2 Standards on dimensions and tolerances (see 7.7.1)

  • EN 10017, Steel rod for drawing and/or cold rolling - Dimensions and tolerances.
  • EN 10024, Hot rolled taper flange I sections - Tolerances on shape and dimensions.
  • EN 10029, Hot rolled steel plates 3 mm thick or above - Tolerances on dimensions, shape and mass.
  • EN 10034, Structural steel I and H sections - Tolerances on shape and dimensions.
  • EN 10048, Hot rolled narrow steel strip - Tolerances on dimensions and shape.
  • EN 10051, Continuously hot-rolled uncoated plate, sheet and strip of non-alloy and alloy steels - Tolerances on dimensions and shape.
  • EN 10055, Hot-rolled steel equal flange tees with radiused root and toes - Dimensions and tolerances on shape and dimensions.
  • EN 10056-1, Structural steel equal and unequal leg angles - Part 1: Dimensions.
  • EN 10056-2, Structural steel equal and unequal leg angles - Part 2: Tolerances on shape and dimensions.
  • EN 10058, Hot rolled flat steel bars for general purposes - Dimensions and tolerances on shape and dimensions.
  • EN 10059, Hot rolled square steel bars for general purposes - Dimensions and tolerances on shape and dimensions.
  • EN 10060, Hot rolled round steel bars for general purposes - Dimensions and tolerances on shape and dimensions.
  • EN 10061, Hot rolled hexagon steel bars for general purposes - Dimensions and tolerances on shape and dimensions.
  • EN 10067, Hot rolled bulb flats - Dimensions and tolerances on shape, dimensions and mass.
  • EN 10162, Cold rolled steel sections - Technical delivery conditions - Dimensional and cross-sectional tolerances.
  • EN 10279, Hot rolled steel channels - Tolerances on shape, dimensions and mass.
4 Likes

ASTM A6 or A20 for appling which production forming.

@Tom: topic’s title questioned material grade EN 10025 S275JR, not ASTM A36/A516/A572 …