Forums > CSWIP  Material  Welding  > Testing  >  Standards > Others

Tagged: 

Viewing 0 reply threads
  • Author
    Posts
    • #13235 Reply
      bien
      Keymaster

      New PQR

      1. Qualified 6GR qualify all position, see Figure 9.25 & Figure 9.26
      2. Min. 2 test coupon qualify material thickness from 3-unlimited, see table 9.10.
      • In case of, CVN requirement for welding procedure, above test coupons also complied with Table 4.6 line 2.
        Minimum thickness qualified is T or 5/8 in [16 mm] whichever is less, except if T is less than 1/4 in [6 mm], then the minimum thickness qualified is 1/8 in [3 mm].
      • Recommend qualify a single process in a test coupon, instead of multiple process in a test coupon. You shall not delete or omission a welding process in a product weld. See Table 4.5 line 34.
        The omission, but not inclusion, of backing or back gouging

      Update

      If a PQR exists which satisfies all requirements except for CVN testing, it shall be
      necessary only to prepare an additional test weldment with enough material to provide the required CVN test specimens. See Subclause 4.27.3.

Viewing 0 reply threads
Reply To: AWS D1.1 2015 new PQR
Your information:




Forums > CSWIP  Material  Welding  > Testing  >  Standards > Others

WIC-2560x512 Community

Services

Contact Us

Following Us

Disclaimer: Weldinginspections.net is based on information from multiple sources and our experience with welding and inspection scopes. It is not a replacement for manufacturers directions and is only to provide reminders for inspector.

© 2019 - 2021 weldinginspections.net | All rights reserved | Privacy Policy